Basic operation and maintenance knowledge of plastic horizontal mixer

The plastic horizontal mixer makes the material agile and evenly mixed. The functional characteristics of the horizontal mixer are that the rotation speed of the reducer drive shaft and the structure of the blades weaken the gravity of the material. With the lack of gravity, there are significant differences in particle size and specific gravity among the materials, which are neglected in the mixing process; How much do you know about the application and maintenance principles of horizontal mixers? The editor will introduce the following content to everyone:

1) The application method of plastic horizontal mixer:

If any abnormal vibration or abnormal noise is found during the use of the horizontal dry powder mixer, it should be stopped immediately for inspection;

2. If it is necessary to scrape the material on the tank wall of the mixer during operation, bamboo and wooden tools should be used, and hands should not be used to avoid injury accidents;

3. The load of the mixer should not be too large. It is generally measured based on the load of the motor. When using a 380V motor for mixing, the overload current should not exceed 6 amperes, which is normal. If the load exceeds, the mixing capacity should be reduced immediately;

4. Before use, a test run of the horizontal dry powder mixer should be conducted by air freight. Before the test run, the firmness of all connecting parts, the amount of lubricating oil in the reducer, and the integrity of the electrical equipment should be checked. Then, the main switch should be closed, the power supply should be turned on, and the machine should be tested by air freight;

2) The maintenance principle of plastic horizontal mixer:

1. Electrical control components should be kept clean and sensitive, and faults should be promptly repaired;
When using or stopping work at once, the remaining materials should be removed from the machine and the remaining powder from each part of the machine should be brushed clean. If the machine is not used for a long time, it needs to be wiped clean and covered with a tarpaulin;

2. Regularly inspect the components, 1-2 times a month, to check whether the moving parts such as worm gear, worm gear, bearings, shaft seals, etc. rotate flexibly and for wear. If defects are found, they should be repaired in a timely manner for normal use。